Assa Abloy Corbin Russwin Access 800 Installation Instructions Manual page 14

5) IP1 (PoE) Installation Wiring (Continued)
A
Frame Harness Installation
Supplied by CI
B-Splice
Crimp Connector
RJ45-M
Ceiling
24AWG
Stranded
Drain
Wire for
Earth
Ground in
15' Frame
Harness
Frame-Side
Harness
Assembly
(15' length)
Cable drain wire
concealed in
shrink tubing
Molex-M
B
Components and wire harness supplied by McKinney: Suggested installation.
Cut end / ceiling-side PoE harness:
Do not confuse pair numbers with pin numbers. A pair number is
used for reference only (eg: 10BaseT Ethernet uses pairs 2 & 3). The
pin numbers indicate actual physical locations on the plug and jack.
Hinge side of PoE harness:
1. Feed cut end of harness into hole on hinge-side through single access
hole.
2. Push one of the connectors back through hole and feed into separate
access hole.
Each of the hinge-side harness connectors should end up threaded
through a different access hole and matched to the same size pin con-
nector from the door harness:
• 4-pin male Molex connector.
• 6-pin male Molex connector with ground wire.
Notes:
• Connectors only go on one way. They cannot be plugged to
incorrect position.
• Do not force and do not offset connectors.
• Be sure they are completely seated (flush).
Frame
14
TIA-568-B Standard Wiring
Pair Number
1 White/Blue
2 White/Orange
3 White/Green
4 White/Brown
4-pin M 4-pin F
B
6-pin M 6-pin F
PoE Hinge (Patent Pending)
Reproduction in whole or in part without the express written
ASSA ABLOY
Wire PIN
White/Blue 5
Blue 4
White/Orange 1
Orange 2
White/Green 3
Green 6
White/Brown 7
Brown 8
Drain Wire
ElectroLynx® is a registered trademark of ASSA ABLOY Inc.
Copyright © 2014 Corbin Russwin, Inc. All rights reserved.
permission of Corbin Russwin, Inc. is prohibited.
®