Assa Abloy Corbin Russwin Access 800 Installation Instructions Manual page 7

Handing of Lock Body
3
Step 1) Move the red locking screw to
side of lock body being locked (Fig. 1)
Step 2) Push in latch then depress catch
plate with screw driver (Fig. 1)
Step 3) Pull latch out of lock body
and turn latch over (Fig. 2)
Figure 2
Step 4) Push in latch while holding
screw driver behind latch tail (Fig. 3)
Note: Push in latch until catch plate is
no longer depressed (Fig. 4)
Step 5) Rotate lock front to match
bevel of door as shown (Fig. 5)
Figure 5
4) Installation Instructions
RED Locking Screw
MAKE SURE CATCH PLATE IS
EVEN W/TOP SURFACE
GOOD
Figure 3
7
ASSA ABLOY
Catch Plate
Figure 1
BAD
Figure 4
WARNING:
LOCK-IN CAN
OCCUR IF LATCH
IS NOT PROPERLY
INSTALLED
ElectroLynx® is a registered trademark of ASSA ABLOY Inc.
Copyright © 2014 Corbin Russwin, Inc. All rights reserved.
Reproduction in whole or in part without the express written
permission of Corbin Russwin, Inc. is prohibited.
®