Tcip1 (Poe) Wiring Instructions - Assa Abloy Corbin Russwin Access 800 Installation Instructions Manual

17.
PoE Frame harness assembly
A
(From McKinney)
PoE data hinge (U.S. Patent No. 7 ,824,200)
B
(From McKinney)
Supplied by CI
B-Splice
Crimp Connector
RJ45-M
Ceiling
24AWG
Stranded
Drain
Wire for
Earth
Ground in
15' Frame
Harness
Frame-Side
Harness
Assembly
(15' length)
Cable drain
wire con -
cealed in
shrink tubing
Molex-M Molex-F
A
5) IP1 (PoE) Installation Wiring
Certified Integrator (CI) supplies and terminates
the B-Splice connector and the
Male RJ45 connector from harness to
end user provided facility cable
Drain Wire
RJ45-F Jack Cable: CAT 5e or higher
24 AWG shielded with drain wire
Cable
: CAT 5e,
B
26 AWG stranded,
shielded, 100ohm
C
Molex-F Molex-M
Ring Terminal
Secured to Lock
Mounting Plate
Wiring to TIA-568-B Standard
C PoE Door harness*
(From McKinney)
Access 700 PIP1 (PoE Lock)
D
* Order of installation may vary.
Refer to appropriate sections for instructions.
Patch Cable:
PoE Panel to
PoE Switch
D
PoE
Lock
JST
4-Pin
4-Pin
Molex
Ground
13
ASSA ABLOY
Supplied by End User
PoE Switch
PoE Patch Panel
Drain Wire Terminated on Rack
Third Party Software
ElectroLynx® is a registered trademark of ASSA ABLOY Inc.
Copyright © 2014 Corbin Russwin, Inc. All rights reserved.
Reproduction in whole or in part without the express written
permission of Corbin Russwin, Inc. is prohibited.
®
PoE Switch
Rack is
Terminated to
Earth Ground