Assa Abloy Corbin Russwin Access 800 Installation Instructions Manual page 9

For ml20800 tcwi1/tcip1 series mortise lockset
Hide thumbs Also See for Corbin Russwin Access 800:
Table of Contents

Advertisement

5
Installation of Outside Escutcheon
1.
For exterior applications, an optional M99 Weatherseal Gasketing Kit can be ordered when a
device is ordered. This kit includes gaskets and a conduit. When ordering the kit separately, order
part number 794F929. The gaskets may be used as a seal between the escutcheon and the door
surfaces.
2A. For fire rated doors, feed ribbon cable connector and ground wire from outside escutcheon through
the fire stop plate.
2B. For non-fire rated doors, feed ribbon cable connector and ground wire from outside escutcheon
through weather seal gasket (if used), then conduit sleeve in door (not shown).
3.
With outside lever horizontal, insert mounting posts into the door. Make certain the lever spindle is
properly engaged in lock. (see diagram and Note A. below) Screw cylinder into mortise lock,
ensuring the cylinder orientation is in the correct position (see diagram below) . Using the 7/64 allen
wrench provided, hand tighten (5-10 in. lbs.) the cap screw to prevent unscrewing of the cylinder.
Turn the key to make certain that the locking mechanism (latch, deadbolt, key) functions correctly.
Tighten (2) #12 x 1" lock body screws. Remove allen wrench.
C A U T I O N
DOOR MUST REMAIN OPEN
DURING INSTALLATION.
USE DOOR STOP.
Use Correct Spindle Orientation
MUSÉO
STANDARD
Lever
Lever
4) Installation Instructions
Ground
Wire
Spindles
GASKET APPLICATION:
Peel off the adhesive protective paper
from gasket. Feed Trim assembly motor
harness through gasket opening as
shown and firmly press gasket to
escutcheon, aligning edge of gasket
with the edge of the escutcheon.
Outside
of Door
Keypad Ribbon Cable
Gasket (optional)
iCLASS Cable
9
ASSA ABLOY
NOTE A.
For MUSÉO Lever
collections ONLY.
Thread hub into lever
and fully tighten.
Align adapter hub
®
with square hole in
lever, keeping hub
as tight as possible.
NOTE: Key and
cylinder must be
rotated as shown
®
Y
A B
LO
SA
AS
®
ASSA ABLOY
Correct
Incorrect
ElectroLynx® is a registered trademark of ASSA ABLOY Inc.
Copyright © 2014 Corbin Russwin, Inc. All rights reserved.
Reproduction in whole or in part without the express written
permission of Corbin Russwin, Inc. is prohibited.
®
®

Advertisement

Table of Contents
loading

Table of Contents