Manual Override; Maintenance - Lippert Components Bed Lift Assembly And Operation Manual

Manual Override

Always disconnect from power source before performing any operation on the bed lifting system.
1.
To raise or lower the bed lift in case of emergency, it is possible to operate the system manually.
2.
Insert the provided crank device (Fig. 38A) into the motor (Fig. 38B).
3.
Turn clockwise to raise or counterclockwise to lower the bed.
NOTE: Have the bed lift serviced by an OEM-authorized dealer as soon as possible. Do not operate the bed
lift until service is complete, as damage to the bed lift system may result.
A

Maintenance

The Bed Lift system has been designed to require very little maintenance. To ensure the long life
of the Bed Lift system, read and follow these few simple procedures:
• When the bed is raised, visually inspect the slide rail assemblies.
• Check for excess buildup of dirt or other foreign material.
• Remove any debris that may be present.
• If the system squeaks or makes any noises, blow out any debris from the drive shaft and apply a dry lubricant
to prevent and/or stop squeaking.
Rev: 11.19.20
Fig. 38
Page 23
B
CCD-0002764