Table of Contents
Advertisement
Adjusting the Running Belt
The running belt is initially set and adjusted at the factory. However it may come loose
during transportation and/or during use. It is recommended that the user run on the center
of the running belt. After prolonged use, the belt will begin to stretch out. It is suggested
that the user always to walk or run on the central area. This will prevent the belt shifting off
the center.
If the running belt begins to shift to the left, the user can stand on the Main Frame and hold
the handlebar with both hands. Then use your right foot to run on the right side of the
running belt. You should see the running belt start to correct itself by moving back towards
the center. However, if the running belt is still shifting to the left, use the S5 Allen Wrench
with Phillips Screwdriver provided and turn the left Hexagon Socket Cheese Head Cap Bolt
1/2 turn in a clockwise direction. Then try running on the center of the running belt again.
If the running belt is still shifting to the left, turn the left Hexagon Socket Cheese Head Cap
Bolt another 1/4 turn in the clockwise direction. Then try running on the center of the
running belt again. You should see the belt start to correct itself by moving back towards
the center. Repeat this procedure until the running belt is centered.
Tool:
S5 Allen Wrench with
Phillips Screwdriver
20
Advertisement
Table of Contents
