H3C MSR 5600 Comware 7 Vxlan Command Reference page 36

Hide thumbs Also See for MSR 5600:
Table of Contents

Advertisement

IP packet frame type: Ethernet II, hardware address: 0011-2200-0102
IPv6 packet frame type: Ethernet II, hardware address: 0011-2200-0102
Physical: Unknown, baudrate: 1000000 kbps
Last clearing of counters: Never
Last 300 seconds input rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Last 300 seconds output rate: 0 bytes/sec, 0 bits/sec, 0 packets/sec
Input: 0 packets, 0 bytes, 0 drops
Output: 0 packets, 0 bytes, 0 drops
Table 8 Command output
Field
Current state
Line protocol state
Description
Bandwidth
Maximum transmission unit
Internet protocol processing: Disabled
Internet address:
ip-address/mask-length (Type)
Description
Physical link state of the interface:
Administratively DOWN—The interface has been shut down
by using the
shutdown
DOWN—The interface is administratively up, but its physical
state is down.
UP—The interface is both administratively and physically up.
Data link layer state of the interface:
UP—The data link layer protocol is up.
UP(spoofing)—The data link layer protocol is up, but the link
is an on-demand link or does not exist.
DOWN—The data link layer protocol is down.
Description of the interface.
Expected bandwidth of the interface.
MTU of the interface.
The interface is not assigned an IP address and cannot process IP
packets.
IP address of the interface and type of the address in parentheses.
Possible IP address types include:
Primary—Manually configured primary IP address.
Sub—Manually configured secondary IP address. If the
interface has both primary and secondary IP addresses, the
primary IP address is displayed. If the interface has only
secondary IP addresses, the lowest secondary IP address is
displayed.
DHCP-Allocated—DHCP allocated IP address. For more
information, see DHCP client configuration in Layer 3—IP
Services Configuration Guide.
BOOTP-Allocated—BOOTP allocated IP address. For more
information, see BOOTP client configuration in Layer 3—IP
Services Configuration Guide.
PPP-Negotiated—IP address assigned by a PPP server
during PPP negotiation. For more information, see PPP
configuration in Layer 2—WAN Access Configuration Guide.
Unnumbered—IP address borrowed from another interface.
Cellular-Allocated—IP address allocated through the
modem-manufacturer's proprietary protocol. For more
information, see 3G/4G modem management in Layer
2—WAN Access Configuration Guide.
MAD—IP address assigned to an IRF member device for MAD
on the interface. For more information, see IRF configuration
in Virtual Technologies Configuration Guide.
30
command.

Advertisement

Table of Contents
loading

Table of Contents