Write Settings To Controller - Club Car IQ Plus 2008 Maintenance And Service Manual Supplement

IQ DISPLAY MODULE (IQDM) SERIES 2 AND IQDM-P DIAGNOSTICS
Executing...
Figure 12-3 Handset Executing

WRITE SETTINGS TO CONTROLLER

This function transfers all of the speed controller settings (except for "private speed mode") from the handset
to the vehicle speed controller. This enables the trained technician to "clone" a speed controller. Once the
speed controller settings have been transferred to the handset, the technician can then connect the handset
to another vehicle and transfer the stored settings into the speed controller.
Speed Controller Cloning – Transferring Settings from the Handset to the Vehicle
1. Perform this procedure with a handset that has the desired speed controller settings. See Speed Con-
troller Cloning – Transferring Settings from the Vehicle to the Handset on page 12-14.
2. Locate a vehicle that does not have the desired speed controller settings.
3. Turn the key switch to the OFF position, place the Forward/Reverse handle in the NEUTRAL position,
and lock the park brake.
4. Plug the handset into the vehicle.
4.1. Connect one end of the cable to the jack located on the bottom of the handset.
4.2. Connect the cable adaptor to the IQDM cable.
4.3. Remove the dust cap from the IQDM jack.
4.4. Align the keyed portion of the plug with the IQDM jack and connect the plug to the jack
(Figure 12-1, Page 12-1).
5. Scroll to the functions menu and select.
2008-2011 IQ Plus Electric Vehicle Maintenance and Service Supplement
All Controller Settings
Saved in Programmer.
OK (+) OK (+)
Figure 12-4 Confirmation Message
12
Faults Menu
Page 12-15