Functions Menu; Get Settings From Controller - Club Car IQ Plus 2008 Maintenance And Service Manual Supplement

12
IQ DISPLAY MODULE (IQDM) SERIES 2 AND IQDM-P DIAGNOSTICS

FUNCTIONS MENU

The functions menu is accessed by using the up or down arrow to scroll to functions and pressing the right
arrow key to activate the menu.

GET SETTINGS FROM CONTROLLER

This function transfers all of the speed controller settings (except for "private speed mode") from the vehicle
speed controller to the handset. This enables the trained technician to "clone" a speed controller. Once the
speed controller settings have been transferred to the handset, the technician can then connect the handset
to another vehicle and transfer the stored settings into the speed controller.
Speed Controller Cloning – Transferring Settings from the Vehicle to the Handset
1. Locate a vehicle that has the desired speed controller settings.
2. Turn the key switch to the OFF position, place the Forward/Reverse handle in the NEUTRAL position,
and lock the park brake.
3. Plug the handset into the vehicle.
3.1. Connect one end of the cable to the jack located on the bottom of the handset.
3.2. Connect the cable adaptor to the IQDM cable.
3.3. Remove the dust cap from the IQDM jack.
3.4. Align the keyed portion of the plug with the IQDM jack and connect the plug to the jack
(Figure 12-1, Page 12-1).
4. Scroll to the functions menu and select.
5. Select settings.
6. Select get settings from controller.
7. Press + on the change value button to confirm the operation.
8. The handset will display an "executing..." message for the next few seconds while the controller settings
are being stored in the handset's memory (Figure 12-3).
9. When the handset is finished recording the speed controller settings, a confirmation message is dis-
played (Figure 12-4).
10. With the controller settings stored in the memory of the handset, the handset can be used to transfer all
of the desired speed controller settings to any IQ Plus vehicle or group of IQ Plus vehicles. See Speed
Controller Cloning – Transferring Settings from the Handset to the Vehicle on page 12-15.
Page 12-14 2008-2011 IQ Plus Electric Vehicle Maintenance and Service Supplement
Faults Menu