Table of Contents
Advertisement
13. Options
a u t o m a t i c a l l y r e t u r n t o t h e S T AB I L I S E R
DISABLED
position
Figure 13.4 - Stabiliser Enable Switch
Setting the automatic stabilisers
When the Au to matic Sta bi liser Op tion is fit ted there
is no need to use the sta bi liser en able switch de -
scribed above.
For au to matic sta bi liser op er a tion re fer to the Op -
er a tion Chap ter.
Operation
Machines with Electric Controls
Once the DC mode is se lected the mo tor will then
power all the func tions in the nor mal man ner, (ex -
clud ing the man ual sta bi liser op er a tion de scribed
above).
The only dif fer ence is that the DC mo tor will only
run when a func tion is se lected e.g. rais ing a boom.
Operation
Machines with Hydraulic Controls
If your ma chine has hy drau lic con trols you will
need to op er ate the ELECTRIC PUMP switch in
comjunction with the movement valve le ver.
These switches are lo cated at the ground con trol
sta tion (see Fig ure 13.5.1) and at the plat form con -
trol sta tion (see Figure13.5.2).
ELECTRIC
PUMP
ENABLE
13166-1
Figure 13.5.1 - Electric Motor Enable Switch
Ground Station, Hydraulic Controls
page 13 - 2
Figure 13.5.2 - Electric Motor Enable Switch
Platform Station, Hydraulic Controls
Note:
The DC motor will only run when a function is
selected (e.g. raising a boom) and either the
ground station or platform station electric pump
enable switches are operated.
Batteries
Since the Bi-en ergy MHP is pow ered by "Deep Cy -
cle Trac tion Bat ter ies" par tic u lar at ten tion should
be paid to the bat ter ies on-board charger to en sure
proper op er a tion.
The bat ter ies are en closed in a cab i net mounted in
front of the gas o line mo tor (see Fig ure 13.6).
CABINET
COVER
LATCH
Figure 13.6 - DC Motor Battery Cabinet
Re move the lock ing catches at each side of the
cab i net and lift the lid off to gain ac cess to the bat -
ter ies (see Fig ure 13.6).
Rev F
PRESS TO ENABLE
ELECTRIC PUMP
13166-3
MHP15/44HD – 12885A
Advertisement
Table of Contents
