Table of Contents
Advertisement
MACHINES WITH HYDRAULIC CONTROLS
CAUTION
EACH PERSON ON THE PLATFORM
MUST WEAR A FULL SAFETY HARNESS
WITH LEG STRAPS
AND ENERGY ABSORBING LANYARD
ATTACHED TO AN APPROVED ANCHOR
POINT IN THE PLATFORM
RATED LOAD
LB
440
MHP15/44HD – 12885A
EMERGENCY
LOWERING
TO LOWER UPPER BOOM TURN
VALVE COUNTER CLOCKWISE
TO LOWER LOWER BOOM, OPERATE
LOWER BOOM CONTROL
TO SLEW, OPERATE SLEW CONTROL
99228-1
99228-1
TO RETRACT FLY BOOM, OPERATE
FLY BOOM CONTROL
0150448
0150448
KG
200
12423-200
12423-200
Rev F
DANGER
ELECTROCUTION
HAZARD
THIS MACHINE IS NOT
ELECTRICALLY INSULATED
13029
13029
DANGER
MAXIMUM ALLOWABLE
WIND SPEED 12.5m/sec
45198-7
45198-7
EMERGENCY BLEED
DOWN VALVE
DANGER
BEWARE OF ELECTRICAL HAZARDS
REGULATION 133A OF THE
CONSTRUCTION SAFETY ACT 1912 REQUIRES
(a) Minimum approach of an appliance
to live electrical apparatus.
(b) Inspection of the work site for
electrical hazards before
commencing to use the appliance.
(c) Constant vigilance and an observer required
whilst working or travelling the appliance
in the vicinity of live electrical apparatus.
(Australia Only)
WARNING
KEEP
CLEAR
OF
POWER
Unless the Electrical Supply Authority has advised
in writing otherwise;
the clearance between any live overhead
power line and any part of this machine or
load carried is required by law to be
AT LEAST 4 METRES
This is a requirement of regulation 93 of the
Electrical Supply Regulations 1984
in the interests of safe working.
(New Zealand Only)
1. Safety
13030
13030
0070420
0070420
3m. for voltages up to 132,000
6m. for voltages above 132,000
and up to 330,000
8m. for voltages above 330,000
9428
LINES
1843
page 1 - 11
Advertisement
Table of Contents
