Table of Contents
Advertisement
1. Safety
MACHINES WITH ELECTRIC CONTROLS
CAUTION
EACH PERSON ON THE PLATFORM
MUST WEAR A FULL SAFETY HARNESS
WITH LEG STRAPS
AND ENERGY ABSORBING LANYARD
ATTACHED TO AN APPROVED ANCHOR
POINT IN THE PLATFORM
RATED LOAD
LB
440
page 1 - 10
99228-1
99228-1
0150448
0150448
KG
200
12423-200
12423-200
DANGER
ELECTROCUTION
HAZARD
THIS MACHINE IS NOT
ELECTRICALLY INSULATED
(ON RAIL IMMEDIATELY ABOVE FRONT OF CONTROL BOX)
DANGER
MAXIMUM ALLOWABLE
WIND SPEED 12.5m/sec
BEWARE OF ELECTRICAL HAZARDS
(a) Minimum approach of an appliance
to live electrical apparatus.
(b) Inspection of the work site for
electrical hazards before
commencing to use the appliance.
(c) Constant vigilance and an observer required
whilst working or travelling the appliance
in the vicinity of live electrical apparatus.
KEEP
Unless the Electrical Supply Authority has advised
the clearance between any live overhead
power line and any part of this machine or
Rev F
13030
13030
ELECTROCUTION HAZARD
This machine is not electrically insulated.
45198-7
45198-7
DANGER
REGULATION 133A OF THE
CONSTRUCTION SAFETY ACT 1912 REQUIRES
3m. for voltages up to 132,000
6m. for voltages above 132,000
and up to 330,000
8m. for voltages above 330,000
(Australia Only)
WARNING
CLEAR
OF
POWER
LINES
in writing otherwise;
load carried is required by law to be
AT LEAST 4 METRES
This is a requirement of regulation 93 of the
Electrical Supply Regulations 1984
in the interests of safe working.
(New Zealand Only)
MHP15/44HD – 12885A
0072531
0072531
9428
1843
Advertisement
Table of Contents
