To Raise The Stabilisers; Operating The Auto Level System; Setting The Stabilisers Automatically - Snorkel S2255RT Operator's Manual

Chapter 8 – Operation
Figure 8.5 – Stabiliser Manual Switches
Ÿ Pull and hold the stabiliser switches backward one
at a time, until all four stabiliser pads contact the
ground (see fi gure 8.5).
Figure 8.6 – Level Bubble
Ÿ Visually check the level bubble to determine which
stabilisers must be further extended to level the
platform (see fi gure 8.6).
Note
When the bubbles are in the center of the marks the
platform is level.
Ÿ Lower the appropriate stabilisers just enough to
center the bubbles (see fi gure 8.6). When the lift
indicator light (see fi gure 8.7) comes on, the platform
can be safely raised.
Lift Indicator
Light
Figure 8.7 – Stabiliser Manual Switches

To raise the stabilisers:

Completely lower the platform. Then push and hold the
stabiliser switches forward until all the stabilisers are
completely up.
44
Stabiliser
Manual Switches
Auto Level Switch
Figure 8.8 – Auto Level Switch

Operating the Auto Level System

Setting the stabilisers automatically

Ÿ The engine must be running and the S2255RT/
S2755RT set for platform control box operation.
Note
In order to operate the Auto Level stabiliser switch you
must squeeze the joystick trigger at the same time as
you operate the Auto Level switch.
You must do this when raising or lowering the
stabilisers.
Auto Level Switch
Figure 8.9 – Auto Level Switch
Ÿ
Press and hold the switch down to the Auto Level
position until all movement stops of the lift enable
light illuminates. The S2255RT/S2755RT will attempt
to automatically level itself.
Ÿ The lift enable light will illuminate if all 4 feet are in
contact with the ground and the machine is level.
Ÿ If a stabiliser foot will not go down suffi ciently to
make contact with the ground it is possible that the
cylinder has reached the end of its stroke. Retract
all stabilisers and put suitable dunnage under the
feet that did not touch the ground and repeat the
second step.
S2255RT S2755RT - 15286-1