Table of Contents
Advertisement
10. Operation
Figure 10.4 - Platform Control Box Emergency
Stop Switch Location
Figure 10.4.2 - Platform Control Box -
Insulated Fibreglass Basket, Emergency Stop
Switch Location
Figure 10.4.3 - Platform Control Box -
Non-Insulated Fibreglass Basket, Emergency
Stop Switch Location
NOTE
For a complete discussion of the Emergency
Stop switches, see "Controls Electric" chapter
7, and "Controls Hydraulic" chapter 8 in this
manual.
Operation Considerations
To use this chapter, first decide whether you will be
starting and operating the MHP15/44HD from the
ground control box or the platform control box.
page 10 - 2
Begin either at the section entitled "Starting From
Ground Control Box - Machines with Electric
Controls", or at the section entitled "Starting From
Ground Control Box - Machines with Hydraulic
Controls" if you intend to start and run the
MHP15/44HD from the ground station.
Stabiliser Operation
NOTE: All Stabiliser Operations
The stabilisers will only function when the booms
are stowed. Once the booms are raised the
stabilisers will not operate.
NOTE: Operating the Stabilisers
Before you can operate the stabilisers you need
to start the engine. See "Starting From Ground
Control Box" on page 4 for electric controls or
page 7 for hydraulic controls.
Using the manual stabiliser valves
Ensure the Boom/Stabiliser Switch (item
ground control box) (see Figure 10.10 or 9.17) is
set to stabiliser.
Activate the stabilisers with the valve le vers (down -
wards). (see Fig ure 10.5)
NOTE:
Ensure that the front stabilisers are lowered first
to prevent damage to the jockey wheel.
Figure 10.5
Lower the rear stabilisers and level the ma chine
us ing the level bub ble (see Fig ure 10.6) ad ja cent to
the con trol le vers.
Rev F
on the
MHP15/44HD – 12885A
Advertisement
Table of Contents
