Siemens 8DB10 Installation And Operating Instructions Manual page 79

Mounting busbar housing
covers without
desiccant bag holders
Bolting
the subframes together
864-5091.9 • INSTALLATION AND OPERATING INSTRUCTIONS • 8DB10 • Revision 06
ATTENTION
In the ambient air, the desiccant bags lose their effectiveness rapidly and cannot be used
anymore.
➭ Use only desiccant bags whose packing is not damaged and whose humidity indicators in
the packing are blue.
➭ Do not use desiccant bags if the humidity indicators are pink.
➭ After opening the packings, mount the desiccant bags in the gas compartment within
30 minutes and close the gas compartment hermetically.
For this reason, the busbar housing covers without a holder for desiccant bags are mounted
first (cover without "Filter" inscription).
➭ Remove tools, clean the inside of the housings with a hand vacuum cleaner, and clean
the bushing plates with a rag.
➭ Prepare the flanges of the cleaned busbar housings for assembly.
➭ Clean the contact surfaces of the busbar housing covers with a lint-free paper, and apply a
thin film of grease (e.g. Polylub GLY 801, 0.40 kg).
➭ Put the covers on the prepared flanges and bolt them tight crosswise.
Tightening torque: 20 Nm.
The subframes of the transport units are bolted together at the panel joints using connecting
links at the front and a connecting plate at the rear.
Fig. 75: Bolting the subframe together
(representation with 4MC4 current
transformer)
① Connecting plate (rear)
② Connecting links (front)
➭ Align adjacent connecting links at the subframes. The holes must be in line.
➭ Bolt the transport units together at the front connecting links using four bolts M10 x 20
(tightening torque 40 Nm), and at the rear connecting plate using two coach bolts
M10 x 20 (tightening torque 40 Nm).
Installation
79/214