Mercedes-Benz E-Class Saloon Owner's Manual page 481

Service products and capacities
478
Assuring the purity of AdBlue
important with respect to avoiding malfunc-
tions in the BlueTEC exhaust gas aftertreat-
ment system.
®
If AdBlue is pumped out of the AdBlue
e.g. during repair work, do not use this fluid to
refill the tank. The purity of the fluid can no
longer be guaranteed.
Capacities
Model
All models
Engine oil
General notes
When handling engine oil, observe the impor-
tant safety notes on service products
( page 473).
Y
The quality of the engine oil is decisive for the
function and service life of an engine. After
extensive tests, Mercedes-Benz approves
engine oils that correspond to the current
technical standard.
Therefore, only Mercedes-Benz approved
engine oils may be used in Mercedes-Benz
engines.
Further information on tested and approved
engine oils can be obtained from any
Mercedes-Benz Service Centre. Mercedes-
Benz recommends that you have the oil
change carried out at a qualified specialist
workshop. Mercedes-Benz approval is indica-
ted on the oil container by the inscription "MB
Approval" and the corresponding designa-
tion, e.g. MB Approval 229.51.
You can call up an overview of approved
engine oils on the Internet at
http://bevo.mercedes-benz.com by enter-
ing the designation, e.g. 229.5.
The table shows which engine oils have been
approved for your vehicle.
Petrol engines: in certain countries, differ-
®
is particularly
ent engine oils can be used, provided that the
maintenance intervals are reduced. For more
information, please contact a qualified spe-
cialist workshop.
®
tank,
Petrol engines
All models
Diesel engines
Total capacity
E 350 CDI
25.5 l
All other models
Use only SAE 0W-40 or SAE 5W-40 engine oils
for AMG vehicles.
i
Capacities
The following values refer to an oil change,
including the oil filter.
Model
E 180
E 200
E 250
If the engine oils listed in the table are not
available, you may add the following engine
oils until the next oil change:
vehicles with a petrol engine: MB
R
Approval 229.1, 229.3 or ACEA A3
vehicles with a diesel engine: MB
R
Approval 229.1, 229.3, 229.5 or ACEA
C3
This must only be added once and the
amount must not be greater than 1.0 l.
MB Approval
229.5
MB Approval
228.51,
229.31, 229.51
228.51,
229.31,
229.51, 229.52
Replacement
amount
6.1 l
6.3 l