Table of Contents
Advertisement
ment cluster where it will be easily seen by
the driver.
! After use, excess tyre sealant may run out
of the filler hose. This could cause stains.
Therefore, place the filler hose in the plastic
bag which contained the TIREFIT kit.
Environmental note
H
Have the used tyre sealant bottle disposed of
professionally, e.g. at a qualified specialist
workshop.
If a tyre pressure of 180 kPa (1.8 bar/26 psi)
has been attained after five minutes:
Switch off the tyre inflation compressor.
X
Unscrew the filler hose from the valve of
X
the faulty tyre.
Stow the tyre sealant bottle, the tyre infla-
X
tion compressor and the warning triangle.
Pull away immediately.
X
Stop after driving for approximately ten
X
minutes and check the tyre pressure with
the tyre inflation compressor.
The tyre pressure must now be at least
130 kPa (1.3 bar/19 psi).
G
WARNING
If the required tyre pressure is not reached
after driving for a short period, the tyre is too
badly damaged. The tyre sealant cannot
repair the tyre in this instance. Damaged tyres
and a tyre pressure that is too low can signif-
icantly impair the vehicle's braking and driv-
ing characteristics. There is a risk of accident.
Do not continue driving. Contact a qualified
specialist workshop.
i
In your vehicle, you will find a sticker with
the Mercedes-Benz Service24h telephone
number, e.g. on the B-pillar on the driver's
side.
Correct the tyre pressure if it is still at least
X
130 kPa (1.3 bar/19 psi). See the fuel filler
flap for values.
To increase the tyre pressure: switch on
X
the tyre inflation compressor.
Battery (vehicle)
To reduce the tyre pressure: depress
X
pressure release button E next to pres-
sure gauge F.
When the tyre pressure is correct, unscrew
X
the filler hose from the valve of the sealed
tyre.
Screw the valve cap onto the tyre valve of
X
the sealed tyre.
Pull the tyre sealant bottle out of the tyre
X
inflation compressor.
The filler hose stays on the tyre sealant
bottle.
Drive to the nearest qualified specialist
X
workshop and have the tyre changed there.
Have the tyre sealant bottle replaced as
X
soon as possible at a qualified specialist
workshop.
Have the tyre sealant bottle replaced every
X
four years at a qualified specialist work-
shop.
Battery (vehicle)
Important safety notes
Work on the battery, e.g. removing or fitting,
requires specialist knowledge and the use of
special tools. Therefore, always have work on
the battery carried out at a qualified specialist
workshop.
G
WARNING
Work carried out incorrectly on the battery
can lead, for example, to a short circuit and
thus damage the vehicle electronics. This can
401
Z
Advertisement
Table of Contents
