Mercedes-Benz E-Class Saloon Owner's Manual page 170

immediately to open/close the side window
in the door. The side window stops. To con-
tinue closing the side window, pull on the
W switch.
Convenience closing feature: press and
X
hold the g button until the side win-
dows and the sliding sunroof or the pano-
rama sliding sunroof are closed.
The indicator lamp above the g button
lights up. Air-recirculation mode is activa-
ted.
If parts of the body are in the closing area
during convenience closing, proceed as fol-
lows:
Press the W button to stop the side win-
X
dows.
The side windows stop.
To then open the side windows, press the
X
W button again.
Press the 3 button to stop the sliding
X
sunroof or panorama sliding sunroof.
The sliding sunroof or panorama sliding
sunroof stops.
To then open the sliding sunroof or pano-
X
rama sliding sunroof, pull back on the 3
button.
i
Notes on the automatic reversing feature
for:
the side windows (
R
the sliding sunroof (
R
the panorama sliding sunroof
R
( page 115)
Y
Convenience opening feature: press and
X
hold the g button until the side win-
dows and the sliding sunroof or panorama
sliding sunroof have opened. The side win-
dows and the sliding sunroof or panorama
sliding sunroof move back to their original
position.
The indicator lamp above the g button
goes out. Air-recirculation mode is deacti-
vated.
Operating the climate control system
page 110)
Y
page 115)
Y
i
If you open the side windows, the sliding
sunroof or the panorama sliding sunroof
manually after closing them with the con-
venience closing feature, they will remain in
this position when opened using the con-
venience opening feature.
Activating/deactivating the residual
heat function
General notes
The residual heat function is only available
with THERMOTRONIC automatic climate con-
trol.
It is possible to make use of the residual heat
of the engine to continue heating the vehicle
for approximately 30 minutes after the engine
has been switched off. The heating time
depends on the set interior temperature.
Activating/deactivating
Turn the key to position 0 in the ignition
X
lock or remove it (
Y
To activate: press the Ì button.
X
The indicator lamp above the Ì button
lights up.
i
If the residual heat function is activated,
the windows may mist up on the inside.
i
The blower will run at a low speed regard-
less of the airflow setting.
i
If you activate the residual heat function
at high temperatures, only the ventilation
will be activated. The blower runs at
medium speed.
To deactivate: press the Ì button.
X
The indicator lamp above the Ì button
goes out.
Residual heat is deactivated automatically:
after approximately 30 minutes
R
when the ignition is switched on
R
if the battery voltage drops
R
when the auxiliary heating is switched on
R
page 179).
Z
167