Table of Contents
Advertisement
Sliding sunroof
118
Opening and closing
Overhead control panel
To raise
:
To open
;
To close/lower
=
To raise
:
To open
;
To close/lower
=
Turn the key to position 1 or 2 in the ignition
X
lock.
Press or pull the 3 switch in the corre-
X
sponding direction.
i
If you press or pull the 3 switch
beyond the point of resistance, automatic
operation is started in the corresponding
direction. You can stop automatic opera-
tion by pressing or pulling again.
Resetting the panorama sliding sun-
roof and the roller sunblind
! If the panorama sliding sunroof and the
roller sunblinds cannot be fully opened or
closed after resetting, contact a qualified
specialist workshop.
Reset the panorama sliding sunroof and the
roller sunblinds if the panorama sliding sun-
roof or the roller sunblinds do not move
smoothly.
Turn the key to position 1 or 2 in the ignition
X
lock.
Pull the 3 switch repeatedly to the point
X
of resistance in the direction of arrow =
until the panorama sliding sunroof is fully
closed (
page 118).
Y
Keep the 3 switch pulled for an addi-
X
tional second.
Pull the 3 switch repeatedly to the point
X
of resistance in the direction of arrow =
until the roller sunblinds are fully closed.
Keep the 3 switch pulled for an addi-
X
tional second.
Make sure that the panorama sliding sun-
X
roof (
page 116) and the roller sunblinds
Y
(
page 118) can be fully opened again.
Y
If this is not the case, repeat the steps
X
above again.
Advertisement
Table of Contents
