Cooling Lubricant - Optimum OPTI turn TU 3008G Operating Manual

4.24

Cooling lubricant

WARNING!
Ejection and overflowing of coolants and lubricants. Make sure you do not get the
cooling lubricants on the floor. Spilled on the floor cooling agents must be removed
immediately.
Friction during the cutting process causes high temperatures at the cutting edge of the tool.
The tool should be cooled during the milling process. Cooling the tool with a suitable cooling
lubricant ensures better working results and a longer service life of the cutting tool.
INFORMATION
The lathe is lacquered with a one-component paint. Consider this fact when selecting your
cooling lubricant.
The company Optimum Maschinen Germany GmbH does not assume any guarantee for
subsequent damages due to unsuitable cooling lubricants.
The flashpoint of the emulsion must be higher than 140°C.
When using non-water-miscible cooling lubricants (oil content > 15%) with a flashpoint, ignitable
aerosol air mixtures might develop. There is a potential danger of explosion.
The selection of cooling lubricants and slideway oils, lubricating oils or greases as well as their
care are being determined by the machine operator or operating company.
Therefore, Optimum Maschinen Germany GmbH cannot be held liable for machine damages
caused by unsuitable coolants and lubricants as well as by inadequate maintenance and
servicing of the coolant. In case of problems with the cooling lubricant and the slideway oil or
grease, please contact your mineral oil supplier.
Operation
GB TU3008G
58 Translation of original instruction Version 1.1.6 - 2021-9-17