Harddisk Installation; Hardware/Software Installation - DTK PAM-0035S User Manual

28
3.5

HARDDISK INSTALLATION

The mainboard on-board built-in the PCI IDE Controller which supports 2
enhanced IDE channels with Primary IDE address on 1F0-1F7, 3F6, 3F7; and
Secondary IDE address on 170-177, 376, 377. Please following the steps shown
below to process installation.
(1) 2 Drives System:
Case A: Set Drive C: to Master; and Drive D: to slave and connect both drives
on IDE 0 connector. Set Drives C: and D: disk parameters in CMOS.
Case B:
(2) 4 Drives System:
Set Drive C: to Master; and Drive D: to slave, and connect both drives
on IDE 0 connector. Set Drive E: to Master; and Drive F: to slave and
connect both drives on IDE 1 connector. Set Drives C:, D:, E: and F:
disk parameters in CMOS.
3.6

HARDWARE/SOFTWARE INSTALLATION

(1) Set Onboard PCI/IDE Chip to "Enable" in BIOS Setup (refer
to Section 4.4.5), then properly connect the IDE cable to IDE drive
connector, and to IDE disk drive(s). The cable should have colored
band to indicate the Pin 1 position. Make sure the IDE drive cable and
the on-board IDE connector are all aligned with
Pin 1 position.
Set Drive C: to Master and connect it on IDE 0 connector; and
Drive D: to Master and connect it on
IDE 1 connector. Set Drives C: and D: disk parameters in
CMOS.
Chapter 3