Table of Contents
Advertisement
∗: Measurement mode can return from any setting item by pressing the SET button for 2 seconds or longer.
∗: An increase or decrease in flow will have no effect on the output while the output operation is being performed.
∗: PD stands for Process data. Refer to page
PD diagnostic bit (error) check
Press the UP or DOWN button
to select diagnostic bit (error)
check.
∗: This function is available with IO-Link communication.
∗: Refer to page
Press the SET button to set.
PD flow measurement check
Press the UP or DOWN button
to select PD flow
measurement check.
∗: This function is available with IO-Link communication.
Press the SET button to set.
[F98] Setting of output check completed.
77
for further details of the PD.
-70-
82
for details of the diagnostic information.
Move on to PD diagnostic
bit (flow) check.
Return to function
selection mode.
No.PF※※-OMZ0002
Advertisement
Table of Contents
