DT SWISS SPLINE ROAD 2015 RC 28 Technical Manual page 20

2. Put the axle (fig. 3-1/3) onto the mounting tool.
3. Put the non disc side of the hub shell onto the tool
and the axle.
4. Slightly grease the bearing (fig. 3-1/2) and put it
onto the disc side with the colored side facing
outwards.
5. Put the dismounting tool onto the axle.
6. Put the mounting tool onto the bearing.
 The dismounting tool centers the mounting
tool on the axle.
7. Tap the bearing into the hub shell with slight
hammer strokes.
 The lower mounting tool must lay on an even
surface.
8. Remove the tool from the hub.
®
SPLINE Wheels - Technical Manual 19