DT SWISS SPLINE ROAD 2015 RC 28 Technical Manual page 41

2. If necessary, cut the spoke:
a) Release the spoke using a screw clamp.
b) Cut the spoke.
c) Take off the screw clamp.
3. Check if there is a washer (PHR washer) on the
nipple.
4. Take the spoke with the nipple out of the rim.
If there is a PHR washer: Take care that the washer
does not fall into the rim profile.
Only for spokes in the inner spoke holes of the hub
flange.
5. Fully loosen the spoke (green) opposite the spoke
head of the spoke (red) that needs to be replaced.
Caution: The figure shows a wheel with bladed
spokes.
Only for spokes in the inner spoke holes of the hub
flange.
6. Put the spoke (green) opposite the head of the
spoke (red) that needs to be replaced into the
middle of the spoke tree.
®
SPLINE Wheels - Technical Manual 40