DT SWISS SPLINE ROAD 2015 RC 28 Technical Manual page 47

3. Position the «spoke tree» in the way that there is
no spoke crossing above the valve hole.
 Check the positioning of the stickers on the
hub and on the rim.
Putting on the Nipple [Conventional SPLINE
Attaching a nipple on a SPLINE ONE Wheel, see
NOTICE
Risk of damage to the bladed spokes and the nipples!
• Bladed spokes must be hold with the spoke holder while turning the nipple.
• Whenever possible, use the universal spoke holder (see
spokes. The spoke holder made out of metal (see
sal spoke holder can't be used due to the high torque.
• Different spokes types are used (see
• To avoid damages to the spoke, slide the spoke holder as far as possible in direction of the rim.
• To avoid damages to the nipples, slide the nipple wrench as far as possible onto the nipple.
1. Screw the nipple onto the spoke until the thread
disappears.
2. Repeat step on all spokes.
Caution: The figure shows a wheel with bladed
spokes.
®
Wheels]
Putting on the Nipple [SPLINE ONE
chap. 5.2, page
chap. 6.1, page
®
SPLINE Wheels - Technical Manual
chap. 5.2, page 36) to avoid damages to the
36) should only be used if the univer-
61). Ensure that the correct tool is being used.
Wheels].
46