DT SWISS SPLINE ROAD 2015 RC 28 Technical Manual page 21

9. Check the bearing.
 The hub must turn smoothly.
 The hub must not have axial play.
10. If necessary tap in the bearing on the non disc side
or loosen the bearing.
11. Repeat previous steps until the hub is turning
smoothly.
Putting on the End Caps
1. Grease the bearings and the inner surface of both
end caps (fig. 3-1/1).
2. Screw on both end caps (fig. 3-1/1) by hand.
3. Tighten the end cap (fig. 3-1/1) with 15 Nm using a
wrench.
 20 mm, 15 mm und 9 mm end caps: 22 mm
open-end wrench
 QR end caps: 5 mm Allen key
Closing Steps
Mount the brake disc.
®
SPLINE Wheels - Technical Manual
Link
see instructions of the manufacturer
20