Inseego Wavemaker PRO User Manual page 27

Turn on DHCP server: This checkbox turns the DHCP Server feature on or off. This should be left
checked. The DHCP server allocates an IP address to each connected device.
is turned off, each connected device must be assigned a fixed IP address.
DHCP Lease Time: The number of minutes in which connected devices must renew the IP address
assigned to them by the DHCP server. Normally, this can be left at the default value, but if you have
special requirements, you can change this value.
Start DHCP Address Range at: The start of the IP address range used by the DHCP server. If the IP is
set on the client device, use an IP address outside of this DHCP range; if the IP address is set using an IP
reservation, it will usually be inside this range.
End DHCP Address Range at: The end of the IP address range used by the DHCP server. If the IP is set
on the client device, use an IP address outside of this DHCP range; if the IP address is set using an IP
reservation, it will usually be inside this range.
IPv6
Turn on IPv6: Check the box if the connected device supports IPv6. This enables IPv6 connected
devices to make IPv6 connections to the Internet.
Link-Local Address: The Link-Local IPv6 address if the connected device supports IPv6.
Click Save Changes to activate and save new settings.
5G OUTDOOR CPE FW2010e USER GUIDE
NOTE:
Only expert users should change this setting.
NOTE:
Only expert users should change this setting.
NOTE:
If the DHCP Server
27