Inseego Wavemaker PRO User Manual page 26

LAN Sub Tab
This page provides settings and information about the FW2010e's local area network (LAN). The LAN
consists of the device and all connected devices.
IP Passthrough
Turn on IP Passthrough: Check the box to enable IP Passthrough. This will enable the first device
detected on the specified interface to obtain the IP address assigned by the mobile network.
When IP Passthrough is turned on, all other devices will lose Internet access. In addition, you will not
be able to make changes to the Firewall, Port Filtering, or Port Forwarding settings.
IPv4
IP Address: The IP address for your FW2010e, as seen from the local network. Normally, you can use
the default value.
Subnet Mask: The subnet mask network setting for the FW2010e. The default value 255.255.255.0 is
standard for small (class "C") networks. If you change the LAN IP Address, make sure to use the correct
Subnet mask for the IP address range of the LAN IP address.
MAC Address: (read-only) The Media Access Controller (MAC) Address for the Wi-Fi interface on your
FW2010e. The MAC address is a unique network identifier assigned when a network device is
manufactured.
5G OUTDOOR CPE FW2010e USER GUIDE
NOTE:
26