3 Unpacking and Storage
I I t t e e m m
N N a a m m e e
A
Inverter
Wall-mounting
B
bracket
Nylon bolts
C
Communication
D
connectors
E
Screw
PV input
F
connectors
Cord end
G
terminal
AC output
H
connectors
I
Documents
* There are two communication port versions for the inverter: single port and dual ports.
For details, refer to the product you receive. The inverter with single communication port
is equipped with one set of communication connector, and the inverter with duel
communication ports is equipped with two sets of communication connectors.
3.4 Inverter Storage
Proper storage is required if the inverter is not installed immediately.
Store the inverter in the original packing case with the desiccant inside.
•
The storage temperature must be always between -40℃ and +70℃, and the
•
storage relative humidity must be always between 0 and 95 %, non-condensing.
In case of stacking storage, the number of stacking layers should never exceed the
•
limit marked on the outer side of the packing case.
The packing should be upright.
•
If the inverter has been stored more than half a year, the qualified personnel should
•
thoroughly check and test it before using.
14
Q Q u u a a n n t t i i t t y y
D D e e s s c c r r i i p p t t i i o o n n
-
1 set
Used to connect the inverter to the
1 pcs
installation site.
Used to fasten wall-mounting bracket
3 sets
onto concrete wall
Used to connect communication
2 sets
terminal. (one set is optional)
Used to lock the inverter mounting ears
1 pcs
and hanging boards.
Including positive and negative
2 pairs
connectors, used to connect PV input.
There are cord end terminals of two
2
specifications (5 for each specification)
specificati-
used to connect AC cables. Select
ons
appropriate terminals according to the
cable cross-section area.
Used to connect PV output, contains
two layers of rubber gasket. The inner
1 pcs
gasket needs to be removed when the
outer diameter of AC cable is
19~25mm.
Quality certificate, packing list, test
1 set
report and quick user manual
User Manual