Adjustment Of The Height Adjusting Support - probst RG-20/80 Operating Instructions Manual

Adjustments
5.1.2

Adjustment of the height adjusting support

The height-adjustable support is adjusted as follows:
•
Pull the spring cotter pin upwards and turn it 180°.
•
Move the rectangular tube until the correct inside height has been adjusted. Pull the spring cotter pin upwards again
and turn it by 180°.
•
Push the rectangular tube back and forth until the spring cotter pin engages in the corresponding hole.
•
The height-adjustable support must always be adjusted so, that the gripping elements always grip the concrete pipe
below the largest pipe diameter, otherwise there is a danger of slipping! Fig. 2
Height adjjustable
suppoert
Fig. 1
5450.0002 V5
12 / 17
Spring cotter
pin
Fig. 2
GB