Operation; Height Adjustment; Operating Of The Device; Special Settings - probst DEZ-UNI Operating Instructions Manual

Operation

5 Operation
5.1

Height adjustment

•
To transport gripping goods like concrete roofing tiles the spring bolt on the height adjustment must be locked in
the upper position.
•
Therefore pull the spring bolt back, position the rectangular tube and lock the spring bolt in the upper hole.
•
For gripping goods like clay roof tiles the spring bolt must be locked either in the upper or in the lower hole,
depending on the size of gripping goods.
5.2

Operating of the device

No pallets loaded with gripping goods (clay roof tiles) may be gripped with the unit (DEZ-UNI)!
•
Place the device No pallets loaded with gripping goods (clay roof tiles) may be gripped with the unit (DEZ-UNI)
over the gripping good using a lifting device and slowly let it down.
•
When the device is laying on the gripping good the automatic release will unlock and the device can be raised up
approx. ½ m above the ground.
For security reasons the safety net must be attached, to prevent gripping goods from falling
down.
•
The safety net is attached to the red handles.
•
Now the device and the gripping good can be moved to the point of destination.
•
When the device is approx. ½ m over the storage point, the safety net can be removed again and the load ca be
put down.
•
As soon as the device is laying on the gripping good, the automatic release get locked and the device can be
raised carefully.
5.2.1

Special Settings

•
If the gripping good has to be dropped on a pitched roof, the chains can be shortened on one side of the device
to cause an inclined position of the device.
•
To do so, mount the shortened chains, which are attached on the lifting eye, so the one side of the device is
lifted.
•
This way it is possible to work with the device in one-man operation on slightly pitched roofs.
However it must be ensured that the gripping good do not slide because of the incline of the
roof.
55100034 13 / 19 GB