Controller Settings - Omron 1S Series Startup Manual
Programmable multi-axis controller (idev4)
Hide thumbs
Also See for 1S Series:
- User manual (976 pages) ,
- Startup manual (100 pages) ,
- Instruction manual (89 pages)
Table of Contents
Advertisement
6.5. Controller Settings
6.5.1.
EtherCAT Communications Check
Take the following steps to ensure that EtherCAT communications are available.
1
From the Terminal tab page, run
the ECAT[0].Enable=1
command to start EtherCAT
communications.
2
In the Terminal tab page or
Watch Window, make sure that
the ECAT[0].Enable value turns
to 1.
*The OP mode is entered and
EtherCAT communications are
established.
3
After making sure that correct
communications are available,
run the ECAT[0].Enable=0
command from the Terminal tab
page to stop EtherCAT
communications.
4
In the Terminal tab page or
Watch Window, make sure that
the ECAT[0].Enable value turns
to 0.
26
Advertisement
Table of Contents
