Determining And Changing The Operating Protocol Mode Using The Qconvergeconsole Cli - Oracle Sun Storage HBA Installation Manual

To Determine and Change the Operating Protocol Mode Using the QConvergeConsole Noninteractive CLI
0 - FC
1 - CNA
enter: 1
.
{0} ok reset-all
Determining and Changing the Operating Protocol
Mode Using the QConvergeConsole CLI
Note -
QConvergeConsole CLI User's Guide.
The QLogic QConvergeConsole command-line interface (CLI) utility is used to configure and
manage QLogic Fibre Channel adapters, Intelligent Ethernet adapters, and converged network
adapters within SANs. The QConvergeConsole CLI has two modes of operation: noninteractive
mode and interactive mode.
Noninteractive mode uses a CLI, in which you type a complete command-line with switches
and associated settings at the operating system prompt. Interactive mode uses a menu-driven
interface that prompts you to select information from menus to perform the desired operation.
Note -
To Determine and Change the Operating Protocol Mode Using
the QConvergeConsole Noninteractive CLI
Follow these instructions to determine and change the operating protocol mode of the universal
HBA using the QConvergeConsole CLI in noninteractive mode in the Windows, Linux, or
Oracle Solaris OS.
1. Open an operating system shell.
2. (Optional) Issue the following command to display the current operating protocol
mode of the universal HBA:
qaucli -pc
Where hba-instance is the HBA instance number of the universal HBA. To discover the
instance number of the universal HBA, you can issue the -g command.
3. Issue the following command to change the operating protocol mode of the
universal HBA:
50 Sun Storage 16 Gb Fibre Channel PCIe Universal Host Bus Adapter, QLogic Installation Guide For HBA Model
7101674 • August 2018
For detailed information on installing the QConvergeConsole CLI utility, see the
The QConvergeConsole CLI is case-sensitive.
hba-instance
--info