Determining And Changing The Current Operating Protocol Mode - Oracle Sun Storage HBA Installation Manual

Determining and Changing the Current Operating Protocol Mode

Universal HBA Configuration
16 Gb FC SW Optical
10 GbE FCoE SR Optical
16 Gb FC LW Optical
Note -
iSCSI.
Determining and Changing the Current Operating Protocol
Mode
As described in
protocol modes (FC only, CNA) is associated with each universal HBA configuration. After
you configure the universal HBA into one of the valid configuration options described in
"Universal HBA Features and Specifications" on page
operating protocol mode is associated with the new universal HBA configuration.
If the correct operating protocol mode is associated with the current configuration of the
universal HBA, you do not need to perform any further steps. Otherwise, you must manually
change the operating protocol mode on the system to the correct mode.
To determine and change the operating protocol mode associated with your universal HBA
configuration, use one of the following tools:
BIOS utility for legacy x86 systems – See
■
Protocol Mode Using the Fast!UTIL Utility" on page
UEFI utilty for x86 systems – See
■
Using the UEFI Setup Menus" on page
FCode for Oracle SPARC systems – See
■
Mode Using the FCode Utility" on page
QLogic QConvergeConsole CLI management tool – See
■
Operating Protocol Mode Using the QConvergeConsole Interactive CLI" on page 51
QLogic QConvergeConsole GUI management tool—See
■
Operating Protocol Mode Using the QConvergeConsole GUI" on page
The information in this section is correct as of the July 2013 release. For the latest information,
refer to the documentation for the management tool that you are using:
BIOS Fast!UTIL utility (legacy x86 servers): Readme file
■
40 Sun Storage 16 Gb Fibre Channel PCIe Universal Host Bus Adapter, QLogic Installation Guide For HBA Model
7101674 • August 2018
Link Aggregation Control Protocol (LACP) cannot be used on the same port as FCoE or
"About the Operating Protocol Mode" on page
Operating Protocol Mode
FC Only
CNA
FC Only
11, you must verify that the correct
"To Determine and Change the Operating
41.
"To Determine and Change the Operating Protocol Mode
46.
"To Determine and Change the Operating Protocol
49.
"To Determine and Change the
"To Determine and Change the
39, one of the two operating
54.
.