Removing The Hardware; To Remove The Universal Host Bus Adapter - Oracle Sun Storage HBA Installation Manual

Universal Host Bus Adapter LED Status Indicators for Fibre Channel Only Mode
TABLE 8
16 Gb FC LED (Amber) 8 Gb FC LED (Green)
Off Off
On On
Flashing Flashing
Flashing in sequence Flashing in sequence
Off Off
Off On or Flashing
On or Flashing Off
Flashing Off

Removing the Hardware

The following instructions describe how to remove the universal HBA. Refer to your system
installation or service manual for detailed removal instructions.
The following steps summarize the hardware removal process:
1. Halt the operating system and remove power from the system.
2. Remove the universal HBA hardware.

To Remove the Universal Host Bus Adapter

1. Attach an ESD strap to your wrist (see
Precautions" on page
Refer to your system documentation to shut down, power off, and unplug the
2.
system.
3. Disconnect all cables.
4. Unscrew the case screws and remove the system case.
Remove the mounting bracket of the universal HBA from the system by
5.
unscrewing the panel screw or removing the clip, whichever is being used.
You can now remove the universal HBA.
4 Gb FC LED (Amber) Activity
Off Power off
On Power on (before firmware initialization)
Flashing Power on (after firmware initialization)
Flashing in sequence Firmware fault
On or Flashing 4 Gb link established (on) and active (flashing)
Off 8 Gb link established (on) and active (flashing)
Off 16 Gb link established (on) and active (flashing)
Flashing Beaconing
"Observing ESD and Handling
21).
Chapter 2 • Universal HBA Installation and Removal
Removing the Hardware
37