Table of Contents
Advertisement
First Time Setup
First Time Setup
Table 6, "First Time Setup Tasks," on page 22
must be performed, to set up a new universal HBA for the first time.
TABLE 6
First Time Setup Tasks
Task
Prepare for hardware installation.
Install the universal HBA into the system.
Connect the cables to the universal HBA.
Apply power to the system, if needed.
Determine the current operating protocol mode of the
universal HBA.
Preparing for Installation
If you choose to configure the universal HBA so that the HBA is connected to SFP+ optical
transceiver modules (see
install the optical transceiver modules before you install the universal HBA into the system.
If you choose to configure the universal HBA using the 10 GbE FCoE Copper configuration,
however, you do not need to perform the steps in
Transceiver Modules " on page
This section explains how to optionally replace the standard PCI bracket on the universal HBA,
and describes how to install and remove an optical transceiver module. The section contains the
following topics:
"To Replace the PCI Bracket" on page
■
"Installing and Removing SFP+ Optical Transceiver Modules " on page
■
"Best Practices For HBA Installation" on page 27
■
22
Sun Storage 16 Gb Fibre Channel PCIe Universal Host Bus Adapter, QLogic Installation Guide For HBA Model
7101674 • August 2018
lists the tasks, in the order in which the tasks
Sections That Cover How to Do This
■
"Preparing for Installation" on page 22
■
"To Replace the PCI Bracket" on page 25
■
"Installing and Removing SFP+ Optical Transceiver Modules
" on page 23
■
"Best Practices For HBA Installation" on page 27
"To Install the Universal HBA" on page 29
■
"To Connect the Copper Cables" on page 31
■
"To Connect the Optical Cables" on page 32
"To Apply Power" on page 34
"Determining and Changing the Current Operating Protocol
Mode" on page 40
"Universal HBA Features and Specifications" on page
"Installing and Removing SFP+ Optical
23.
25.
11), you must
23.
Advertisement
Table of Contents
