4�2 Communication, Parameter Setting, Evaluation; 4�3 Switching Function - IFM PN72 Series Operating Instructions Manual

Description
Applications
Designation IODD
Manual operating mode selection, see (→ 9.2),
selection of the operating mode via IO-Link interface see
→ Additional document: Selection of the operating mode, at www.ifm.com.
4.2 Communication, parameter setting, evaluation
• Switching signal for system pressure limit
OUT1 (pin 4)
• Communication via IO-Link
OUT2 (pin 2) • Switching signal for system pressure limit
4.3 Switching function
OUTx changes its switching status if it is above or below the set switching limits
(SPx, rPx)� The following switching functions can be selected:
• Hysteresis function / normally open: [OUx] = [Hno] (→ fig. 1).
8
Operating mode 3
High IO-Link process value and parameter resolution
(device-specific: see operating mode of the corresponding IODD)�
The menu points [ou1] and [ou2] are extended by the setting
option [OFF] (→ 9.4.1)�
IO-Link standard command "Flash on" is available (→ 4.4.2)�
The following IO-Link markings are available: Application Specific
Tag, Function Tag and Location Tag (→ 4.4.2)�
This operating mode is available as of device status
BA�The device status is indicated on the unit�
Better controllability via IO-Link�
Highly granular setting of switch-on and switch-off points�
Example PN7294 Status_B High Resolution / (CMPT = 3):
At www�ifm�com in the download area of the corresponding
article�
PNxxxx