Wiring; Interface Connections (Rear Of Unit) - Furuno TZT16F Installation Manual

2.

WIRING

2.1

Interface Connections (Rear of Unit)

NMEA2000 NMEA2000
NETWORK1/2 NETWORK1/2
1
* : Lay the ground wire away from this unit's power cable.
2
* : Use of the extension cable (C332 10M) may cause the following problems:
- Reduced detection ability
- Wrong ACCU-FISH™ information (fish length smaller than actual length, fewer fish
detections, error in individual fish detection).
- Wrong speed data
- No TD-ID recognition
* 3 : Depending on the transducer type, 12-10P Conversion cable is not required.
EMI
Core
TO: 12 to 24 VDC
MULTI cable MULTI cable
VIDEO-IN 1/2 VIDEO-IN 1/2
Rear of TZT16F Rear of TZT16F
12-10P
Conversion Cable
FRU-CCB12-MJ-01
*3
(0.4m, supplied)
Power Cable
FRU-3P-FF-A002M-
001 2 m, supplied)
TO: Transducer or to
Fish Finder Power
Amplifier DI-FFAMP
HDMI HDMI
IN/OUT IN/OUT
DI-FFAMP DI-FFAMP
USB1 USB1
USB2 USB2
microB microB
Ground wire
(Local supply,
1
IV-8sq.)*
TO: Ship's ground
*2
Transducer Cable
2-1