Table of Contents
Advertisement
3. HOW TO SET UP THE EQUIPMENT
Menu item
[Fish Finder Demo
Mode]
[Set Hardware to
Factory Default]
[Restore Default
Settings]
Transducer Setup menu
Note 1: Make sure that the unit is set to stand-by when setting up the transducer.
Note 2: When using with the DI-FFAMP, DO NOT set the [Model Number] menu if the
[Transducer Setup Type] menu is set to [Model]. This can cause damage to the trans-
ducer.Select [Transducer Setup Type] menu and select the model of connected trans-
ducer at [High Frequency] and [Low Frequency] menus.
Note 3: When the DI-FFAMP is connected and [Transducer Setup Type] menu is set
to [Manual], the message "Power amplifier unit detected: In order to manually adjust
your transducer setup, please contact your Furuno dealer." appears. Contact your
FURUNO dealer for setup.
Menu item
[Transducer Setup
Type]
[Model Number]
[High Frequency Min]
[High Frequency Max] Display the high frequency maximum.*
[Low Frequency Min]
3-16
Enable or disable the demonstration mode for the
sounder.
• [OFF]: Disable the demo mode.
• [Shallow]: Enable shallow water demo mode.
• [Deep]: Enable deep water demo mode.
Note: For internal fish finder and DI-FFAMP users, the set-
tings are as follows:
[Off], [Demo1] to [Demo4].
Reset the external fish finder to its factory default settings. [OK], [Cancel]
Restore all menu settings to default.
Select the type of transducer connected.
When the connected sounder is a DFF1-UHD and the
transducer has a compatible TDID, [TDID] is automati-
cally selected.
Note: When the transducer model is changed or TDID is
detected, the frequency and bandwidth set on [Manual] is
to be reset.
• [Manual]: Manually set up the transducer.
• [Model]: Select the appropriate transducer model
(for FURUNO or AIRMAR transducers).
Select the appropriate model number from the list.
Note: Only available when [Transducer Setup Type] is set to [Model].
Display the high frequency minimum.*
Display the low frequency minimum.*
Description
DO NOT use this menu for selecting
DO NOT use this menu for selecting
the connected transducer.
the connected transducer.
Use this menu for selecting the
connected transducer.
Description
Options (setting
range)
[OFF], [Shallow],
[Deep]
[OK], [Cancel]
Options
(setting range)
[Manual],
[Model]
Advertisement
Table of Contents
