Resetting The Temperature Limiter; Technical Specifications - Nibe EMINENT-35 E Installation And Maintenance Instructions Manual

Hide thumbs

Table Of Contents

Table of Contents

Available languages

Emptying

Emptying takes place through the safety valve's overﬂow

pipe and is done as follows:

Switch off the power to the water heater.

Close the shutoff/non-return valve by turning

the knob (22) clockwise until it bottoms.

Turn the mixing valve's knob (25) anticlockwise

to the maximum position.

Open the safety valve by turning the knob (23)

slowly anticlockwise a quarter turn until it

remains in the raised position.

NOTE! Water may splash by the overﬂow pipe.

Remove the venting screw (45) and open the

lowest placed hot water tap on the pipe system.

NOTE! Water may splash out of the venting

screw hole and could be hot.

Compressed air can be applied through the venting

screw hole to increase the emptying speed.

Maintain the position of the valves after the above ac-

tions until the water heater is to be used again.

NOTE! The overﬂow pipe must be connected to

pos (43).

Technical speciﬁcations

Volume

Max workingpressure

Voltage

Enclosure class

Output

Fuses required at 1/3 kW

Heating time to 45 °C at 1/3 kW*

Heating time to 80°C at 1/3 kW*

Net weight E/CU/R

Sacriﬁcial anode EMINENT-E

Corrosion protection EMINENT-E

Corrosion protection EMINENT-CU

Corrosion protection EMINENT-R

* With incoming cold water of 10 °C.

(litres)

(MPa/bar)

(kW)

(A)

(hours)

(kg)

(mm)

EMINENT-E/CU/R 35, 55, 100, 120

Actions with operating disruptions

Check the installation's fuses and the setting of the

thermostat and mixing valve.

Wait a few hours without tapping any hot water and

then check whether the temperature level has risen. If

there is still no hot water, contact the installation

engineer.