System Settings; Performing System Settings; Switching Off The Isocal Function - Sartorius Cubis MCE series Operating Instructions Manual

System Settings

36 Cubis ® MCE Operating Instructions
7 System Settings
7.1

Performing System Settings

Default settings can be adjusted for the device and the applications in order to align
with the ambient conditions and individual operating requirements .
The following settings are necessary to operate the device together with connected
components:
− Set up the communication of the connected devices
− Set up additional components
The following settings are recommended to set up the device:
− Set the menu language
− Set the behavior of the isoCAL function
− Set the behavior of the motorized draft shield (only for devices with a motorized
draft shield)
Procedure
Press the [Menu] button .
t
Open the desired settings menu .
t
To adjust settings: Open the desired main menu and submenu .
t
Select and confirm the desired configuration value (configuration values, see
t
Chapter "7 .3 Parameter List", page 37) .
Exit the menu .
t
If settings have been adjusted in the "SETUP", "DEVICE", "DATA .OUTP ." or
y
"APPLIC ." menu: The [BOOTING] display appears in the operating display and the
device restarts .
7.2

Switching Off the isoCAL Function

If the isoCAL function is switched off for a conformity-assessed device, the device
can only be used for legal-for-trade applications in restricted temperature ranges
(see Chapter "15 .6 .2 Ambient Temperature for the isoCAL Function", page 70) . The
isoCAL function cannot be switched off for all model versions .
Procedure
In the "SETUP" / "BALANCE" menu, for the "ISOCAL" parameter, select the "OFF"
t
configuration value .