Toshiba B-EX Series Operation Manual page 85

NOTES: 1. If the bottom edge of the last label advances past the feed roller while the
[Method 2] Adjust the cut position fine adjustment value.
When this procedure is used, one or more printed labels are left between the head and
the cutter. Therefore, these labels need to be removed by an issue or a label feed.
(a) Cut position fine adjustment value calculation
The cut position fine adjustment value can be calculated using the following method.
If a back feed to the proper home position cannot be performed using this value, the
cut position needs to be adjusted with any value.
Cut position fine
adjustment value
Ex) Label pitch: 30.0 mm
Cut position fine
adjustment value
print head is lifted during label feed to cut, the sensor may not be able to
detect an error even if the label cannot be fed any more.
2. If the head-up solenoid temperature is high when a cut issue is about to be
performed with the head lifted, the head may not be lifted.
(Number of labels left
=
between head and cutter)
32.8 mm
=
Label pitch
=
= 1 × 30.0 mm
= +30.0 mm
80
×
(Label pitch)
× (Label pitch)
* Any decimal remainders are
rounded off.
32.8 mm
× (30.0 mm)
30.0 mm