Toshiba B-EX Series Operation Manual page 12

* Whether to display or hide the 1
mode.
* Refer to "Icon display" for Icon in detail.
(*1) The number of labels printed is the cumulative number of labels printed while the printer is activated. It is
reset to zero when the printer is turned on. During an issue with the cut interval specified, the number of
labels is updated when the label is cut normally.
(*2) [The number of remaining labels to print] = [Specified number of labels to print] – [The number of normally
printed labels before occurrence of an error or placing the printer in pause]
When the number of remaining labels to print is zero, it is not displayed. During an issue with the cut
interval specified, the number of remaining labels is updated when the label is cut normally.
(*3) The help guide is displayed only when applicable help message exists.
(*4) The message displayed in this area is IP address or supplemental information like ribbon near end.
When LAN/WLAN setting is disabled, the IP address is not displayed even if displaying IP address is
•
enabled in the system mode.
The ribbon near end message is displayed when a ribbon near end is detected, regardless of whether or
•
not displaying the ribbon near end message is enabled in system mode.
A ribbon near end is detected depending on diameter of the unused ribbon. The diameter of 38mm is
equivalent to 30-meter ribbon and the diameter of 43 mm is equivalent to 70-meter ribbon, respectively.
(*5) The model name description
B-EX 4 T 1 – T
(*6) The ribbon near end message may be displayed on this line. The condition for display is the same as *4.
st rd th
, 3 and 4 lines of online mode display can be selected in the system
Head resolution G: 203dpi, T: 305dpi, H: 600dpi
Type 1: Type1, 2: Type2
Print method T: Thermal transfer/Direct thermal
Print width 4: 4" width, 6: 6" width
Series model
7