Installation; Location - Thermo Scientific TSX Series Installation And Operation Manual

Installation

7 Installation
WARNING: Risk of Shock. Do not exceed the electrical rating printed on
the data plate located on the upper left side of the unit.
Do not move the unit using the drain pan on the back. This could cause damage
to the equipment.

7.1 Location

Install the unit on a level area free from vibration with a minimum of 6 inches of
space on the sides and rear and 12 inches at the top. Do not position the
equipment in direct sunlight or near heating diffusers, radiators, or other sources
of heat.
WARNING: Risk of Injury. Do not move the unit while loaded. Unit shall
always be moved when empty and by pushing slowly at handle level or lower
on the unit. Be especially careful on any uneven surfaces.
7.1.1 Installation Instructions
The unit must be level both front to back and side to side when installed. If
the unit is out of level, you may need to shim the corners or casters with thin
of metal. Be sure to set the brakes for units equipped with casters.
An unlevel unit may result in instability and performance issues for the doors and
drawers.
9
Thermo Scientific TSX -20°C Flammable Materials Storage Laboratory Freezers