Operating Standards; Unit Specifications - Thermo Scientific TSX Series Installation And Operation Manual

Operating Standards

6 Operating
Standards

6.1 Unit Specifications

Table 2. Unit Specifications
Rated Rated
Model
Voltage Current
23A 115 V 5.56 A
8
TSX -20°C Flammable Materials Storage Laboratory Freezers
The freezers described in this manual are classified for use as stationary
equipment in a Pollution Degree 2 and Overvoltage Category II environment.
These units are designed to operate under the following environmental
conditions:
• Indoor use
• Altitude up to 2000 m (6512 feet)
• Maximum relative humidity 60% for temperatures from 15 to 32°C
(59 to 90°F).
• Main supply voltage fluctuations not to exceed 10% of the nominal
voltage.
• The freezer must not be connected to a GFCI (Ground Fault Circuit
Interrupter) protected outlet as it may be subject to nuisance tripping.
Operation outside of these conditions will affect the performance of the unit
and the samples stored inside.
The last character in the model number listed on the freezer identifies the
electrical specifications for your unit.
The dataplate is located on the upper left side of the unit.
Approximate
Power
Frequency Lab Freezer
Module
/ Phase Weight
Plug
Kg (lbs)
IEC
60 Hz 178 (394)
C19
Approximate
Exterior
Freezer
Dimensions
Weight Kg
(D x W x H)
(lbs)
203 (449) 93.6 x 71.1 x 199.4 cm
(36.9 x 28.0 x 78.5 in)
Hydrocarbon
Refrigerant
R290, 145 g
Thermo Scientific