Thermo Scientific
7. Once the slide is seated in the rear pilaster, rotate the slide until it is
parallel with the unit wall and insert slide into front pilaster.
Figure 6. Slide Installation
CAUTION: Ensure the slide is level. If the slide is not seated in a level
orientation, the drawers/baskets will not function as intended. This could
cause injury or product damage.
8. Replace the safety clip by hooking the clip under the front pilaster slide
bracket. Then rotate the wire safety clip over the top of the same
bracket.
Figure 7. Clip Replacement
CAUTION: Drawer slides do not require lubrication. Additional lubricant
could impede movement of the drawers when lubricant is cold.
TSX -20°C Flammable Materials Storage Laboratory Freezers
Installation
15