Thermo Scientific TSX Series Installation And Operation Manual page 17

-20c flammable materials storage laboratory freezers

Hide thumbs Also See for TSX Series:

Table of Contents

7.4.2 Reinstalling the Drawers

7.4.3 Changing Drawer

Thermo Scientific

To reinstall the drawers, complete the following steps (refer to Figure 2):

1. Pull both the slides of the drawer towards you until the slides are fully

extended.

2. Position the drawer between the slides and with the back facing end

raised at 45 degree angle, insert the mounting clips at the front into the

slots on front of the slides.

3. Push the back of the drawer down between the slides and insert the

basket tabs into the slots at the back.

Note The drawers fit snugly between the slides. Push on the back of the

drawer from the inside to insert the drawer tabs completely into the slots.

Make sure both the drawer tabs are aligned with the slots on the slides

before pushing the drawer down between the slides.

CAUTION: Be careful when reinstalling the drawers to avoid possible

pinching.

Drawer slides have a small wire safety clip at the front pilaster which prevent the

Position

slides from falling when the drawer is removed. To change the position of the

drawer slides, complete the following steps:

1. Locate the safety clip.

2. Slip a small screwdriver under the bottom of the wire clip and pry the

clip towards the inside of the freezer.

Figure 3. Clip Removal

TSX -20°C Flammable Materials Storage Laboratory Freezers

Installation

Table of Contents

Tsx2320h