Table of Contents
Advertisement
.
You may access the SmartNode through the console management port, or through the
Ethernet management port. Refer to the following sections for more information:
8.1 "Accessing the SmartNode via the Console Management port"
•
8.2 "Accessing the SmartNode via the Ethernet Management port"
•
8.1 Accessing the SmartNode via the Console Management port
Logging into the SmartNode Console
1.
To physically connect the console serial port, follow the instructions in
necting the console serial port"
2.
To communicate with the SN10200A through the console port, you must first
configure a terminal emulator or console application (such as HyperTerminal or
Putty) in order to configure initial settings. Configure the terminal emulator with
the following settings:
Baud rate
9600
3.
Log into the console using the specific credentials included on the 'Important
Notice' that shipped with your unit. (If you do not have the "Important Notice"
sheet, contact support@patton.com).
8.2 Accessing the SmartNode via the Ethernet Management port
Logging into the SmartNode via SSH
1.
To physically connect the Ethernet management port, follow the instructions in
7.2 "Connecting the Ethernet management interface"
2.
To access the SN10200A, you must use an SSH connection. The password is set
at the factory and is indicated on the "Important Notice" sheet included with your
unit. (If you do not have the "Important Notice" sheet, contact support@pat-
ton.com).
SmartNode 10200A Series Quick Start Guide
Figure 10.
Connecting the management interface
8.0 Configuring the SmartNode
Data rate
8 bits
Ethernet Management
Port (MGMT0)
MGMT0
ETH
VOIP
TMS
0
1
0
1
0
on page 8.
Parity
Stop bits
None
1
Flow control
1
on page 8.
on page 9
on page 9
7.1 "Con-
None
9
Advertisement
Table of Contents
