Factory Default Firewall Configuration - Fortinet FortiGate FortiGate-4000 Installation Manual

Getting started

Factory default firewall configuration

FortiGate-4000 Installation Guide
Table 13: Factory default Transparent mode network configuration (Continued)
Management IP
Management access
Out of band
management
interface
DNS
FortiGate firewall policies control how all traffic is processed by the FortiGate unit.
Until firewall policies are added, no traffic can be accepted by or pass through the
FortiGate unit. The factory default configuration contains one firewall policy. (Some do
not contain any firewall policies.) To allow traffic through the FortiGate unit you can
add firewall policies. See the FortiGate Administration Guide for information about
adding firewall policies.
The following firewall configuration settings are included in the default firewall
configuration to make it easier to add firewall policies.
Table 14: Default firewall configuration
Configuration setting Name
Firewall address
Pre-defined service
Recurring schedule
Protection Profiles
Firewall policy
01-28004-0028-20040830
IP:
Netmask:
Internal
External
Out of Band
IP:
Netmask:
Default Gateway:
Management Access:
Primary DNS Server:
Secondary DNS Server:
Description
All Firewall address matches the source or destination
address of any packet.
More than 50 Select from any of the 50 pre-defined services to
predefined control traffic through the FortiGate unit that uses that
services service.
Always The recurring schedule is valid at any time.
Strict, Scan, Control how the FortiGate unit applies virus
Web, scanning, web content filtering, spam filtering, and
Unfiltered IPS.
n/a n/a
Factory default configuration
10.10.10.1
255.255.255.0
HTTPS, Ping
Ping
Ping, HTTPS
172.16.1.2
255.255.255.0
172.16.1.1
HTTPS, Ping
207.194.200.1
207.194.200.129
39