10/100 Out Of Band Management Module - Fortinet FortiGate FortiGate-4000 Installation Manual

Getting started

10/100 out of band management module

FortiGate-4000 Installation Guide
Figure 10: Management module
Mounting Knot
On/Off switch
ID dial
ERR LED
Not used
Console
port
Mounting Knot
Table 6: Management module controls
Button
On/Off switch
ID dial
Console port
Table 7: KVM switch module LED
LED State Description
ERR Off Normal operation.
Yellow System fault. Contact Fortinet Technical Support.
The 10/100 out of band management module provides dedicated ethernet connection
to manage each FortiBlade-4010 module installed in the FortiGate-4000 chassis. This
out of band connection is not shared by other network connections. The 10/100 out of
band management module contains two 10/100 ethernet interfaces that connect to
the management interface of each FortiBlade-4010 module.
Note: You can connect to the LAN 1 connector or to the LAN 2 connector but not both.
01-28004-0028-20040830
ERR ERR
Not used
Description
Turns the management module on and off. The management
module must be turned on to establish a serial connection to
the CLI of each FortiBlade-4010 module.
Set to 0.
Serial connection to the CLI of each FortiBlade-4010 module.
Rear panel features
23